Prefa­bri­ca­tion – Finishing

It goes without saying that our parts are deli­vered to the custo­mer perfectly debur­red, chip-free and clean. But the demands on surface, look and feel are constantly incre­asing. We are constantly trying to meet this trend and also want to be pioneers.

The realiza­tion of a good surface starts with the mate­rial, runs through the entire produc­tion chain and only concludes at ship­ping. Besi­des almost all possi­bi­li­ties of debur­ring and clea­ning, we can also polish most plas­tics in case of special requi­re­ments. Here we are helped by our expe­ri­ence in the produc­tion of crys­tal-clear plas­tics. Depen­ding on the mate­rial, compo­nent and contour, we achieve surface finis­hes up to an Ra value < 0.1. Howe­ver, this process is very time-consum­ing and is only recom­men­ded for very special applications.